SLI S1689 Manuel d'utilisateur télécharger pdf (Page 23)

Chapter 2

After being disconnected for a certain period of time, the poly-fuse will return to its

normal state and the keyboard or USB connector can function properly again. Unlike

conventional fuses, the poly-fuse will not need to be replaced, relieving users from

such inconveniences.

CN11 (Front Panel Connector):

PWR-SW (Over-ride Power Button Connector):

The power button on the ATX chassis can be used as a

normal power switch as well as a device to activate the

Advanced Power Management Suspend mode. This is a

power-saving mode used for saving electricity when the computer is idle for long

periods of time. The Soft-OFF by PWR-BTTN function in BIOS's Power

Management Setup menu must be set to [Delay 4 Sec.] to activate this function.

When the Soft-OFF by PWR-BTTN function is enabled, pressing the power button

rapidly will switch the system to Suspend mode. Any occurrence of external activities

such as pressing any keys on the keyboard or moving the mouse will bring the system

back to Full-On. Pushing the button while in Full-On mode for more than [4 seconds]

will switch the system completely off. See Over-ride Power Button Operation

diagram.

1. P-LED (Power LED Connector):

The power indicator LED shows the system's power status. It is important to pay

attention to the correct cable and pin orientation (i.e. Be careful not to reverse the

order of these two connectors.)

2. SL-SW (Sleep Switch):

Some ATX cases provide a Sleep switch, which is used to put the system in

Suspend mode. While in Suspend mode, the power supply to the system is reduced

to a trickle, the CPU clock is stopped, and the CPU core is in its minimum power

state. The system is activated whenever the keyboard or mouse is touched. The

system will resume in various ways as defined by Power Management Setup

screen in BIOS.

3. RESET (System Reset Switch Connector):

This connector should be connected to the reset switch on the front panel of the

system case. The reset switch allows you to restart the system without turning the

power off.

4. SPEAKER (Speaker Connector):

This 4-pin connector connects to the case-mounted speakers.

If you want to use the On-board Beep function, as shown in the above figure,

please insert the jumper into this port.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Pas de commentaire

SLI S1689 Manuel d'utilisateur Page 23